Ot-systems FTD100Micro Bedienungsanleitung PDF herunterladen (Seite 7)

FTD100Micro Series Installation & Operation Manual

www.ot-systems.com 7

(a) Installation (b) Side view of the clip (c) Side view of the Micro unit pushed into the clip

Fig. 3.3 Micro unit installation on the clip

d) Connect all the signal inputs and outputs at the back of the unit with appropriate cables: fiber

optic cable for optical link, BNC cable for video input/output (Tx/Rx).

e) Once the unit is powered up, check that the red POWER LED on the unit is lit. If not, check

the power supply cable connections between the unit and the power supply socket.

f) With all the signals available at the input and output ports, check the status of LEDs located

on the unit. With correct status of each LED, installation is now completed [for LEDs status, see

Operational Guides on this manual’s section (5)].

(4) Cable Connections & Setup Procedures

4.1 System cable connections

Signal Type

Cable Type

Connector

Optical

Single-mode or Multi-mode Fibers

ST (or FC) Connector

Video

Coaxial Video Cable

BNC Connector

1 2 3 4 5 6 7 8 9 10 11

Keine Kommentare

Ot-systems FTD100Micro Bedienungsanleitung Seite 7